Author Topic: 289 HI PO Block  (Read 1279 times)

Offline Karl @ GT

  • Newbie
  • *
  • Posts: 10
289 HI PO Block
« on: March 18, 2017, 07:44:12 PM »
289 hi po block, 030 over,  just cleaned, blasted, tumbled & magged.
C5AE-E    casting date: 6B21
$1,750.00  or best offer,   plus freight,  will pack on a pallet at no charge,
we have daily truck freight service
thanks, 
 

Offline jwc66k

  • Hero Member
  • *****
  • Posts: 7099
Re: 289 HI PO Block
« Reply #1 on: March 19, 2017, 01:49:29 PM »
Does the block have a VIN stamped on the RH front section near the battery ground and just above where the oil pan attaches?
Jim
I promise to be politically correct in all my posts to keep the BBBB from vociferating.

Offline Karl @ GT

  • Newbie
  • *
  • Posts: 10
Re: 289 HI PO Block
« Reply #2 on: March 19, 2017, 02:17:17 PM »
yes,   6T07K240288   

I will make sure that is the correct VIN,   I have 2 hi po blocks and one complete hi po for sale.

later

Offline jwc66k

  • Hero Member
  • *****
  • Posts: 7099
Re: 289 HI PO Block
« Reply #3 on: March 19, 2017, 04:22:30 PM »
Thanks. I "assisted" in the retrieval of a Shelby block two weeks ago and wanted to see if this was another. And, supposedly Metuchen was "lax" on stamping HP blocks so this makes a big dent in that claim. The "lax" could be a date range related thing though.
Jim
« Last Edit: March 20, 2017, 12:01:44 AM by jwc66k »
I promise to be politically correct in all my posts to keep the BBBB from vociferating.

Offline amishtechnology

  • Newbie
  • *
  • Posts: 31
Re: 289 HI PO Block
« Reply #4 on: March 19, 2017, 06:54:25 PM »
Where are you located?

Offline Karl @ GT

  • Newbie
  • *
  • Posts: 10
Re: 289 HI PO Block
« Reply #5 on: March 19, 2017, 07:18:57 PM »
20 miles NW of Philadelphia,   Collegeville

Offline Karl @ GT

  • Newbie
  • *
  • Posts: 10
Re: 289 HI PO Block
« Reply #6 on: March 20, 2017, 03:35:42 PM »
Hello,   Yes,  one complete hi po ready to run,   I will get the details asap.

Another bare block,   I have the casting dates already, will look

Another block machined with pistons fitted,  will get details asap.

Regards, Karl


Offline 67convt

  • Newbie
  • *
  • Posts: 7
Re: 289 HI PO Block
« Reply #7 on: March 21, 2017, 01:59:43 AM »
Hi Karl,

Please give me a call when you get a chance about a what you might still have for sale.  I'm in the market for a short or long block - depending on what you may have available.  Thank you,

Dana
703-939-1741