1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year > 1967 Mustang

67 - Rebuilding brake distribution valve

(1/4) > >>

FD234:
Feb 67 Dearborn gta 390.  I need some help with rebuilding my brake proportion valve. As of yet I have not been able to remove the valve from the proportion valve block .Any tips would be appreciated  I did watch the video posted by west coast classic cougar and successfully rebuilt the proportion valve located by the rear axle.
Thanks fd234

jwc66k:
That is not a proportioning valve, it's a distribution block with a brake fluid warning light switch, and that bit of info does not help you get it apart. From what I remember, the switch has to come off and the actuating pin removed so the piston can be slid out.
Jim

67gta289:
Search for other posts.  I struggled and attempted a few things, then Marty recommended that I heat it, then whack it good on a block of wood with the insert down.  It popped right out. Not too much heat, I only used propane.

FD234:
I have the switch removed and I have tried heating it.  No luck

67gta289:
Whack it.  Seriously. 

Navigation

[0] Message Index

[#] Next page