Author Topic: 67 SJ undercoating and paint process  (Read 5234 times)

Offline Bossbill

  • Hero Member
  • *****
  • Posts: 3249
  • In the middle of project hell
Re: 67 SJ undercoating and paint process
« Reply #15 on: December 16, 2017, 08:48:02 PM »
As always, thanks for the specific time line shots, Jeff. The right panel is really interesting. I'll use that!

Yes, I did mean the 'hard red line' to the right.

I received my Fusor application gun and was aching to try it. But, the gods of sound deadening (watching too many Vikings episodes) are frowning on me and the gun was missing a few pieces. There are still lots of other parts of the car to clean and prep, but this whole application gun fiasco is wearing thin.
Bill
Concours  Actual Ford Build 3/2/67 GT350 01375
Driven      6/6/70 0T02G160xxx Boss 302
Modified   5/18/65 5F09A728xxx 347 Terminator-X 8-Stack
Race        65 2+2 Coupe conversion

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24175
Re: 67 SJ undercoating and paint process
« Reply #16 on: December 16, 2017, 10:12:02 PM »
As always, thanks for the specific time line shots, Jeff. The right panel is really interesting. I'll use that!

Yes, I did mean the 'hard red line' to the right.

On that note-
The hard red line on the right is where the spray material ends (softly).

Yes on that example that is the forward or outer edge of where the worker stopped applying

The soft yellow line is where the outer wheelhouse appears to have been covered. No overspray here. If any is present it would be very light.

They didn't have time to cover just controlled the application, had plenty of practice and kept away from the area of the outer wheel well and tried to stay away from where they meet
Jeff Speegle

Anything worth doing is worth doing concours ;)