Author Topic: "Almost" a Mustang--hose clamp question  (Read 1786 times)

Offline DeadStang

  • Newbie
  • *
  • Posts: 43
"Almost" a Mustang--hose clamp question
« on: February 16, 2010, 09:32:02 PM »
I'm working on...something..and it has a few of those old tower style hose clamps with the long screw that goes in and the clamp comes out toward the screw?  The screw broke at the clamp, but the lower 1/2 of the screw is still firmly in place within the clamp and the clamp is TIGHT.  Any ideas on getting this off?  It's for a heater hose to the water pump.

I can post pictures if this doesn't make any sense...

Thanks!

Offline carlite65

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 2362
Re: "Almost" a Mustang--hose clamp question
« Reply #1 on: February 16, 2010, 09:42:39 PM »
can you cut it with a hacksaw just beside the screw ??
5F09C331248

Offline CharlesTurner

  • Charles Turner
  • Administrator
  • Hero Member
  • *****
  • Posts: 7614
Re: "Almost" a Mustang--hose clamp question
« Reply #2 on: February 16, 2010, 10:06:31 PM »
Use a pair of side cutters and cut/twist it off.
Charles Turner - MCA/SAAC Judge
Concours Mustang Forum Admin

Offline DeadStang

  • Newbie
  • *
  • Posts: 43
Re: "Almost" a Mustang--hose clamp question
« Reply #3 on: February 16, 2010, 11:14:23 PM »
I was thinking of taking a long chisel or screw driver and beating on the end of it to knock the rest of the screw sideways and (hopefully) loose, but that probably won't work.  I'll try the hacksaw or a really big set of bolt cutters and see if I can get it.

This is a 1964 Mercury Comet Cyclone with a 289-4V.  I am still a tiny bit optimistic that we can make it run...the engine still turns, but my hopes are fading the deeper into this I am getting.