Author Topic: 1969 Firewall hole size needed.  (Read 188 times)

Offline Scott302

  • Full Member
  • ***
  • Posts: 164
1969 Firewall hole size needed.
« on: March 26, 2024, 04:10:11 PM »
I am looking for the diameter of this hole in the center of the firewall.  The under dash main harness with a grommet and wires for the wiper, engine gauge feed harness and others pass through here.

Regards,
Scott
Scott Halseth
Ford Product Manager
National Parts Depot
MCA#01776

Offline jwc66k

  • Hero Member
  • *****
  • Posts: 7098
Re: 1969 Firewall hole size needed.
« Reply #1 on: March 26, 2024, 07:08:57 PM »
I would assume that is for underdash harness, 14401, and if I got to punch a feed thru hole for any harness, I measure the diameter of the grommet's groove and use a chassis punch.
Him
I promise to be politically correct in all my posts to keep the BBBB from vociferating.

Offline Scott302

  • Full Member
  • ***
  • Posts: 164
Re: 1969 Firewall hole size needed.
« Reply #2 on: March 26, 2024, 09:04:04 PM »
Not why I need it.  I need to verify the original dimension.
Scott
Scott Halseth
Ford Product Manager
National Parts Depot
MCA#01776

Offline JohnSlack

  • Newbie
  • *
  • Posts: 43
Re: 1969 Firewall hole size needed.
« Reply #3 on: March 27, 2024, 06:32:45 PM »
Scott,
If nobody else answer before I get out to the shop this afternoon and slide the harness out. I'll let you know.


John

Offline JohnSlack

  • Newbie
  • *
  • Posts: 43
Re: 1969 Firewall hole size needed.
« Reply #4 on: Today at 03:37:55 AM »
Scott,
If nobody else answer before I get out to the shop this afternoon and slide the harness out. I'll let you know.


John

Sorry Scott I couldn't get the harness out to measure the hole for you.


John

Offline Scott302

  • Full Member
  • ***
  • Posts: 164
Re: 1969 Firewall hole size needed.
« Reply #5 on: Today at 10:03:14 AM »
Thanks for trying.
Scott Halseth
Ford Product Manager
National Parts Depot
MCA#01776