ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1967 Mustang => Topic started by: jackrob on November 14, 2017, 10:15:37 AM

Title: 67 Heater control installation
Post by: jackrob on November 14, 2017, 10:15:37 AM

How does the lower screws on the heater control panel (no AC) mount on the dash. I have some slots down there but no holes.
Thanks
Jack

Title: Re: 67 Heater control installation
Post by: BKnapp on November 14, 2017, 11:19:10 AM

I think you need 2 8-32x1/2” hex head bolts and nuts. Check out Jims hardware spreadsheet in the Library, along with the Osborn Assembly manual.

Title: Re: 67 Heater control installation
Post by: jackrob on November 14, 2017, 12:20:02 PM

Thanks for the reply. Are you saying to screw the bolts through the slots?

Title: Re: 67 Heater control installation
Post by: 67gta289 on November 14, 2017, 12:42:41 PM

yes

Title: Re: 67 Heater control installation
Post by: BKnapp on November 14, 2017, 12:47:23 PM

IIRC the nut goes on the inside of the dash and the bolt goes up through the slots and threads into the nut. It is a challenge getting them to mate up if you have a fully installed interior. I think they went to a spring nut in 68.

Title: Re: 67 Heater control installation
Post by: jackrob on November 14, 2017, 02:39:52 PM

Thanks Guys!!!