Author Topic: 67 Heater control installation  (Read 721 times)

Offline jackrob

  • Newbie
  • *
  • Posts: 4
67 Heater control installation
« on: November 14, 2017, 10:15:37 AM »
How does the lower screws on the heater control panel (no AC) mount on the dash. I have some slots down there but no holes.
Thanks
Jack

Offline BKnapp

  • Full Member
  • ***
  • Posts: 237
Re: 67 Heater control installation
« Reply #1 on: November 14, 2017, 11:19:10 AM »
I think you need 2 8-32x1/2” hex head bolts and nuts. Check out Jims hardware spreadsheet in the Library, along with the Osborn Assembly manual.
Bill

‘67 390 Coupe A/T  P/S  P/B. (Built 1/4/1967)  7R01S145xxx
‘67 390 FB A/T P/S P/B (Built 3/10/1967) 7F02S173xxx
2007 Shelby GT500 40th Anniv.  Convert. #125

Offline jackrob

  • Newbie
  • *
  • Posts: 4
Re: 67 Heater control installation
« Reply #2 on: November 14, 2017, 12:20:02 PM »
Thanks for the reply. Are you saying to screw the bolts through the slots?

Offline 67gta289

  • Hero Member
  • *****
  • Posts: 3009
Re: 67 Heater control installation
« Reply #3 on: November 14, 2017, 12:42:41 PM »
yes
John
67 289 GTA Dec 20 1966 San Jose
7R02C156xxx
MCA 74660

Offline BKnapp

  • Full Member
  • ***
  • Posts: 237
Re: 67 Heater control installation
« Reply #4 on: November 14, 2017, 12:47:23 PM »
IIRC the nut goes on the inside of the dash and the bolt goes up through the slots and threads into the nut. It is a challenge getting them to mate up if you have a fully installed interior. I think they went to a spring nut in 68.
Bill

‘67 390 Coupe A/T  P/S  P/B. (Built 1/4/1967)  7R01S145xxx
‘67 390 FB A/T P/S P/B (Built 3/10/1967) 7F02S173xxx
2007 Shelby GT500 40th Anniv.  Convert. #125

Offline jackrob

  • Newbie
  • *
  • Posts: 4
Re: 67 Heater control installation
« Reply #5 on: November 14, 2017, 02:39:52 PM »
Thanks Guys!!!