1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year > 1967 Mustang
67 - Rebuilding brake distribution valve
FD234:
Feb 67 Dearborn gta 390. I need some help with rebuilding my brake proportion valve. As of yet I have not been able to remove the valve from the proportion valve block .Any tips would be appreciated I did watch the video posted by west coast classic cougar and successfully rebuilt the proportion valve located by the rear axle.
Thanks fd234
jwc66k:
That is not a proportioning valve, it's a distribution block with a brake fluid warning light switch, and that bit of info does not help you get it apart. From what I remember, the switch has to come off and the actuating pin removed so the piston can be slid out.
Jim
67gta289:
Search for other posts. I struggled and attempted a few things, then Marty recommended that I heat it, then whack it good on a block of wood with the insert down. It popped right out. Not too much heat, I only used propane.
FD234:
I have the switch removed and I have tried heating it. No luck
67gta289:
Whack it. Seriously.
Navigation
[0] Message Index
[#] Next page
Go to full version