Marketplace > Wanted Ads
WTB: Screws and brackets GTA console 1967 AT
Ralf:
Hello,
I'm looking to find the 3 screws and 3 brackets to hold the shift-indicator PRNDL in place.
Anyone any idea where to find?
Thx
Ralf
68GT/CSconvmod:
Chris Brost in Portland Oregon rebuilds consoles should have parts.
cbrost3@yahoo.com or 1-503-334-7675
Troy
Ralf:
--- Quote from: 68GT/CSconvmod on February 13, 2018, 08:43:04 PM ---Chris Brost in Portland Oregon rebuilds consoles should have parts.
cbrost3@yahoo.com or 1-503-334-7675
Troy
--- End quote ---
Thx again, Troy.
Have sent an e-mail. Let's see.
General problem, most will not ship to GER.
Ralf
jwc66k:
Ralf,
When ever I see a hardware question, I do some research. I "may" have the brackets. They are C7ZZ-7E150-A (ref 75 MPC Sec A71 pg 8) and are common to 67 and 68. I measure the width at 5/8 inch, length at 1 11/16 inches, mounting hole - 0.215 in dia. I would like someone to verify these measurements.
The associated screws, 52879-S2, as shown in the 67 Mustang Chassis Assembly Manual, AM0020 pg 24, have no documentation (they are not listed in current available reference material). I recommend that the 1968 screws, 52720-S8, be substituted.
(In my search thru my junk pile for the brackets, I found some of the special clips, 378523-S32, used on 64 and 65 heater cables at the control. They are not reproduced. Thanks for the incentive to do a search.)
P/M sent.
Jim
Ralf:
I would like to give a big hand to Jim for his support and finally the parts he is going to send to me.
Ralf
Navigation
[0] Message Index
[#] Next page
Go to full version