Author Topic: 1965 lower control arm jack tab measurements  (Read 1554 times)

Offline GCROWD

  • Newbie
  • *
  • Posts: 5
1965 lower control arm jack tab measurements
« on: January 03, 2015, 10:46:00 PM »
Happy New Year.  Could someone please do me a favor and measure the jack tabs on a 65/66 lower control arm?  I am going to fabricate some to add to mine.


I see NPD sells the jack tabs for 67+ but they look different to me (they have bolt holes).  I believe the 65/66 had no holes in the tabs and were just welded on.

I am looking for measurements of width, height, as well as A and B below:

         _____
____|         |____
< A >< B >< A  >     


I don't believe it matters, but the car is a March 65 Dearborn 289 convertible.

Thank you in advance.

Offline Bob Gaines

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 8956
Re: 1965 lower control arm jack tab measurements
« Reply #1 on: January 03, 2015, 10:57:58 PM »
Happy New Year.  Could someone please do me a favor and measure the jack tabs on a 65/66 lower control arm?  I am going to fabricate some to add to mine.


I see NPD sells the jack tabs for 67+ but they look different to me (they have bolt holes).  I believe the 65/66 had no holes in the tabs and were just welded on.

I am looking for measurements of width, height, as well as A and B below:

         _____
____|         |____
< A >< B >< A  >     


I don't believe it matters, but the car is a March 65 Dearborn 289 convertible.

Thank you in advance.
The holes on the NPD jack tabs are not bolt holes but a area to weld the tabs to the arm to mimic the factory way which was spot welds . Yes 67-70 jack tabs are different the 65/66 tabs. Not surprising since so many other aspects are different between 65/66 and 67-70.
Bob Gaines,Shelby enthusiast, Shelby collector , Shelby concours judge SAAC,MCA,Mid America Shelby