Author Topic: Convertible well liner plastic reinforcement for edges  (Read 501 times)

Offline CharlesTurner

  • Charles Turner
  • Administrator
  • Hero Member
  • *****
  • Posts: 7614
Convertible well liner plastic reinforcement for edges
« on: December 29, 2017, 06:33:36 PM »
Does anyone know where to purchase the correct size plastic strip used to reinforce the edges of original well liners?  It's black shiny plastic, semi-rigid, 1" wide and about 1/24" (0.041") thick.  Ideally, could buy in a roll.

On a 67-68, it was used along the top where the well liner screws to the convertible tack bars and where the well liner screwed down to the trunk floor.  It was also used on 65-66, but I don't have an original well liner here to know if it was the same dimensions.
« Last Edit: December 31, 2017, 03:17:53 PM by caspian65 »
Charles Turner - MCA/SAAC Judge
Concours Mustang Forum Admin

Offline CharlesTurner

  • Charles Turner
  • Administrator
  • Hero Member
  • *****
  • Posts: 7614
Re: Convertible well liner plastic reinforcement for edges
« Reply #1 on: December 31, 2017, 03:18:30 PM »
Moved to 67/8 section... anyone?
Charles Turner - MCA/SAAC Judge
Concours Mustang Forum Admin