Author Topic: Teak radio bezel reproduced?  (Read 1859 times)

Offline BillEBobb

  • Full Member
  • ***
  • Posts: 108
Teak radio bezel reproduced?
« on: April 30, 2010, 07:04:15 PM »
Have any of you seen the teak radio bezel reproduced?  If so, by whom?

Thanx, Bill

Offline rockhouse66

  • Hero Member
  • *****
  • Posts: 927
Re: Teak radio bezel reproduced?
« Reply #1 on: May 01, 2010, 12:23:34 AM »
I bought the light walnut/teak woodgrain material from NPD and stuck it on a new repro bezel.
Jim
'66 GT FB

Offline BillEBobb

  • Full Member
  • ***
  • Posts: 108
Re: Teak radio bezel reproduced?
« Reply #2 on: May 02, 2010, 01:35:43 PM »
I bought the light walnut/teak woodgrain material from NPD and stuck it on a new repro bezel.

How does it look?

Offline rockhouse66

  • Hero Member
  • *****
  • Posts: 927
Re: Teak radio bezel reproduced?
« Reply #3 on: May 02, 2010, 06:53:27 PM »
Not sure my very subjective reply will help you much, but I would say it looks good.  The fit was OK (not perfect) and the woodgrain color is a match for the new repro console shift plate I installed at the same time.  Not a perfect match to the original dash/clock surrounds IMO, but close enough to look "factory" and those two items are far enough away that you can't directly compare the woodgrains.

I'm not sure what the alternatives are anyway???  I have never seen a NOS light walnut/teak radio bezel.
Jim
'66 GT FB