Author Topic: 1966 rear bumper alignment/installation  (Read 99 times)

Offline socalgt

  • Sr. Member
  • ****
  • Posts: 420
1966 rear bumper alignment/installation
« on: August 31, 2017, 06:34:55 PM »
I know there are a lot of problems getting the rear bumper to align nicely with the body.  Sometimes the problem is the reproduction bumper and/or brackets.  My bumper was not aligned well...the bumper was a repro and so were the brackets.  I found an original set of brackets, straightened them and restored them.  I used them with no additional washers, just the wavy washers installed between the bumper and brackets(one at each location) and the bumper fit perfectly.  In my case it was the repro mounting brackets that were the problem.  Thought I'd share this as I know how many cars have misaligned rear bumpers and how time consuming it can be to try to correct it.

Offline caspian65

  • Charles Turner
  • Administrator
  • Hero Member
  • *****
  • Posts: 5703
Re: 1966 rear bumper alignment/installation
« Reply #1 on: September 01, 2017, 12:56:39 AM »
A long standing rule of mine is to not mix repro parts together.  I've run into the same issue way in the past when mixing repro bumper brackets with a repro bumper.  You'll have the same issue with the front bumper... stick with OEM brackets.
Charles Turner - MCA/SAAC Judge
Concours Mustang Forum Admin