Author Topic: 69-70 washer bottle  (Read 2453 times)

Offline mach1one

  • Full Member
  • ***
  • Posts: 133
69-70 washer bottle
« on: January 24, 2010, 07:36:46 PM »
Is there a rubber body plug in the hole on the front apron the washer bottle fits up against. It seems to me that having a plug here makes it hard to install the plastic bottle strap to the apron without bending it.I've seen this plug put in some cars at shows and it just doesn't seem right Any thoughts Lu

Offline rmaginnis

  • Jr. Member
  • **
  • Posts: 86
    • December 2010
Re: 69-70 washer bottle
« Reply #1 on: January 26, 2010, 02:03:58 AM »
Is there a rubber body plug in the hole on the front apron the washer bottle fits up against. It seems to me that having a plug here makes it hard to install the plastic bottle strap to the apron without bending it.I've seen this plug put in some cars at shows and it just doesn't seem right Any thoughts Lu
I don't think mine has a plug behind the bottle but I'll take a look and let you know what I find.
Rick
Rick Maginnis
April, '70 Dearborn Boss 302
0F02G18xxxx

Offline rmaginnis

  • Jr. Member
  • **
  • Posts: 86
    • December 2010
Re: 69-70 washer bottle
« Reply #2 on: January 28, 2010, 02:25:57 AM »
After closer inspection I do see the plug. It is installed from the wheel side so the smaller rubber button is into the engine compartment. It is close, but does not interfere with the washer's horizontal mounting strap.
Rick
« Last Edit: February 03, 2010, 01:19:29 AM by rmaginnis »
Rick Maginnis
April, '70 Dearborn Boss 302
0F02G18xxxx