« previous next »
Pages: [1]   Go Down

Author Topic: Heater Resistor switch  (Read 1489 times)

Offline sparky65

  • Sr. Member
  • ****
  • Posts: 410
Heater Resistor switch
« on: October 29, 2010, 05:46:25 PM »
Is there a way to remove and reinstall the heater resistor switch from the heater case?  the original switch in my busted up case looks nicer and I would like to swap it but I don't see how I can save the plastic clips that hold it in place.
Logged
Steve
1967 Pebble Beige  I6 Coupe built in Metuchen on Oct 26, 1966.
2009 Black GT Coupe

 

Offline Twilight65

  • Gold Level Subscriber
  • Sr. Member
  • *****
  • Posts: 380
Re: Heater Resistor switch
« Reply #1 on: October 29, 2010, 07:16:51 PM »
You can drill out and replace the plastic rivets. Here's a link to a previous thread.

http://www.concoursmustang.com/forum/index.php?topic=798.msg4089#msg4089
Logged
65 Coupe Dearborn Scheduled Build July 9,1965 289/C4
66 Sprint Conv. Dearborn Scheduled Build May 13, 1966 200/C4

Offline CharlesTurner

  • Charles Turner
  • Administrator
  • Hero Member
  • *****
  • Posts: 7623
Re: Heater Resistor switch
« Reply #2 on: October 30, 2010, 01:05:12 AM »
The plastic pins can be pushed out from the back side and re-used.
Logged
Charles Turner - MCA/SAAC Judge
Concours Mustang Forum Admin

Offline sparky65

  • Sr. Member
  • ****
  • Posts: 410
Re: Heater Resistor switch
« Reply #3 on: October 30, 2010, 03:52:55 PM »
Thanks Charles.  I had tried that but couldn't get them to move.  I just soaked them with WD-40 and then I was able to get them out.
Logged
Steve
1967 Pebble Beige  I6 Coupe built in Metuchen on Oct 26, 1966.
2009 Black GT Coupe

 

Offline CharlesTurner

  • Charles Turner
  • Administrator
  • Hero Member
  • *****
  • Posts: 7623
Re: Heater Resistor switch
« Reply #4 on: October 31, 2010, 01:40:14 PM »
Small tip screwdriver and a rubber mallet usually works.
Logged
Charles Turner - MCA/SAAC Judge
Concours Mustang Forum Admin
Pages: [1]   Go Up
« previous next »