Author Topic: 70 GT500 Pictures - Seen at SAAC 09  (Read 5533 times)

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24177
70 GT500 Pictures - Seen at SAAC 09
« on: August 19, 2009, 12:12:07 AM »
Been a bit busy but wanted to post a couple of pictures from a 70 GT500 some of us got an opportunity to view at the SAAC show this year

Will add more later/soon

Car is 0F02R482901


The metal hose in the upper section is the vent hose for related to the retrofitting of some of the cars





Jeff Speegle

Anything worth doing is worth doing concours ;)

Offline thefordshow

  • Full Member
  • ***
  • Posts: 105
  • fordcountry@bell.net
Re: 70 GT500 Pictures - Seen at SAAC 09
« Reply #1 on: August 19, 2009, 08:03:26 PM »
Nice detail Jeff, thanks for sharing.

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24177
Re: 70 GT500 Pictures - Seen at SAAC 09
« Reply #2 on: August 19, 2009, 09:11:15 PM »
Your welcome -


Also take note of where the side stripe tape was pulled into the marker light holes  rather than neatly cut off at the edges

Anyone else find a anti-rattle "pad" between the vent hose and the upper quarter panel?
Jeff Speegle

Anything worth doing is worth doing concours ;)

Offline Bob Gaines

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 8956
Re: 70 GT500 Pictures - Seen at SAAC 09
« Reply #3 on: August 21, 2009, 12:18:01 PM »
I don't remember seeing that pad before. It must not have been needed often.  I went back and reviewed the instruction TSB sheet sent to the dealers and nothing was illustrated or discussed which leads me to believe (my opinion) it must be a "as needed" item .   Bob
Bob Gaines,Shelby enthusiast, Shelby collector , Shelby concours judge SAAC,MCA,Mid America Shelby

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24177
Re: 70 GT500 Pictures - Seen at SAAC 09
« Reply #4 on: August 21, 2009, 09:16:35 PM »
Thanks Bob - just something that turn up in the pictures when I "developed" them ;)
Jeff Speegle

Anything worth doing is worth doing concours ;)

Offline astat1

  • Jr. Member
  • **
  • Posts: 58
Re: 70 GT500 Pictures - Seen at SAAC 09
« Reply #5 on: August 27, 2009, 05:08:02 PM »
Is the taillight protector hardware the same as sold by AMK?

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24177
Re: 70 GT500 Pictures - Seen at SAAC 09
« Reply #6 on: August 28, 2009, 02:18:36 AM »
Is the taillight protector hardware the same as sold by AMK?


"Taillight protector hardware"?  Not sure what your referring to. Sorry its been a long drive and a long day
Jeff Speegle

Anything worth doing is worth doing concours ;)

Offline astat1

  • Jr. Member
  • **
  • Posts: 58
Re: 70 GT500 Pictures - Seen at SAAC 09
« Reply #7 on: August 28, 2009, 10:21:10 AM »
Hi Jeff, referring to the bolts that attach the grey cardboard taillight protectors to the inner trunk.

Offline Bob Gaines

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 8956
Re: 70 GT500 Pictures - Seen at SAAC 09
« Reply #8 on: August 28, 2009, 06:51:45 PM »
Hi Jeff, referring to the bolts that attach the grey cardboard taillight protectors to the inner trunk.
I don't know what AMK sells but the nuts are the same as the end cap nuts and a zinc phosphate or plated silver and carriage bolt (believe 1 inch 1/4 20) that fits in the slot in the tail panel .  There are two self tapping screws similar to the ones that hold the tail panel on that hold down the cardboard taillight protectors on ether side of the trunk lid latch support structure. There will be holes where they had been installed before. Bob
Bob Gaines,Shelby enthusiast, Shelby collector , Shelby concours judge SAAC,MCA,Mid America Shelby

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24177
Re: 70 GT500 Pictures - Seen at SAAC 09
« Reply #9 on: September 05, 2009, 12:36:54 AM »
Labeling some more of the tens of thousands I've collected this year and thought I would post some additional ones of this particular car.

Hope these help others


One more of the trunk and the back of the non-fold down/ Take note of the poor exterior paint coverage in some areas





Short trip around the engine compartment



















« Last Edit: September 05, 2009, 12:39:48 AM by J_Speegle »
Jeff Speegle

Anything worth doing is worth doing concours ;)

Offline mach1one

  • Full Member
  • ***
  • Posts: 133
Re: 70 GT500 Pictures - Seen at SAAC 09
« Reply #10 on: February 12, 2010, 01:57:24 AM »
Nice shot of truck tailight covers. Is the tailight cover slotted or is there a clean hole for the 2 bolts to go thru the covers and the nuts attached? Could not make that out from the pictures. Thanks Lu

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24177
Re: 70 GT500 Pictures - Seen at SAAC 09
« Reply #11 on: February 12, 2010, 11:06:51 PM »
Nice shot of truck tailight covers. Is the tailight cover slotted or is there a clean hole for the 2 bolts to go thru the covers and the nuts attached? Could not make that out from the pictures. Thanks Lu

Blew the passenger side and it has material over the nut so no slot to the outer edge. Would guess (what I'm doing) is a slightly oversized hole that is smaller than the nut/washer
Jeff Speegle

Anything worth doing is worth doing concours ;)