I've checked the assembly manual and have confirmed that washer 379297-S is intended for use at the center link end. This washer matches size anyways of the one I removed from the idler arm bushing to shaft location. I suppose I could assume assembly line versions also had the NATURAL FINISH on both washers.
AMK has no listing on this item per say. Perhaps I could measure the washer and see if a substitute in the correct finish is available with a different AMK listing or cross reference. I have located a hardware store washer (zinc plated) that matches the two washers removed in size and thicknes and I suppose I could simply remove the zinc and throw those in a tumbler.
Looking for what others are doing or have done for these washers.
« Last Edit: February 09, 2017, 07:15:22 AM by 67gtasanjose »
MCA Certified Judge, 67-68
1967 (11/2/66, S.J.) Luxury Coupe, 289-4V w/Thermactor Emissions, C-4, Well Optioned
2005 (04/05) GT Premium Convertible, Windveil Blue, Parchment Top w/Med. Parchment interior, Roush Body Appointments