Author Topic: 65 Convertible metal strip  (Read 752 times)

Offline Sig 65

  • Newbie
  • *
  • Posts: 14
65 Convertible metal strip
« on: April 20, 2017, 02:30:02 PM »
I am trying to figure out what the metal strips that hold down the convertible top on the inside to the body in the back.. There is one long one under the window and two smaller ones on the sides.  Also what are they supposed to look like?  Painted, chromed, Top color, bodycolor?   Any help appreciated.

Sig
« Last Edit: April 20, 2017, 04:13:33 PM by J_Speegle »

Offline CharlesTurner

  • Charles Turner
  • Administrator
  • Hero Member
  • *****
  • Posts: 7614
Re: Convertible metal strip
« Reply #1 on: April 20, 2017, 03:50:54 PM »
They are tacking strips for the convertible top.  Yes, they are supposed to look like that.  The well liner would cover them.

'66 and up went to a different design where those short pieces were made longer and were curved.  This was to enable the rear window to be removed without pulling staples off the tack strips.

Normally the bottom edge is trimmed, so guessing this is a replacement top.
Charles Turner - MCA/SAAC Judge
Concours Mustang Forum Admin

Offline Sig 65

  • Newbie
  • *
  • Posts: 14
Re: Convertible metal strip
« Reply #2 on: April 20, 2017, 04:07:16 PM »
Thank you very much. So they were just bare metal?

Offline CharlesTurner

  • Charles Turner
  • Administrator
  • Hero Member
  • *****
  • Posts: 7614
Re: Convertible metal strip
« Reply #3 on: April 20, 2017, 04:50:40 PM »
Thank you very much. So they were just bare metal?

It's a galvanized or zinc plated finish usually.
Charles Turner - MCA/SAAC Judge
Concours Mustang Forum Admin