1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year > 1966 Mustang
'66 Autolite 4100 4V accelerator pump rod retainer
socalgt:
Looking for the original retainer used on the accelerator pump rod at the throttle shaft linkage. I have a feeling this isn't it.
socalgt:
The one that came with the rebuild kit looks a bit "flimsy"(see photo)....is there another available?... perhaps the original was stronger and could be reused.
jwc66k:
That's it, and try to get it off. It ain't flimsy.
Jim
socalgt:
The spring is on two 4300 carbs I have also.... Can't imagine why someone would add it if it serves no purpose.
Hipo giddyup:
I have seen this on 4300 carbs (with it's own bracket in front of the primary linkage), but not on the 4100's. The comment is just enforcing what would be concours correct, to be helpful, not offensive. ;D
Navigation
[0] Message Index
[#] Next page
Go to full version