1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year > 1968 Mustang
'68 302, Correct clip for lower Z-bar attachment to adjustment rod?
CharlesTurner:
The assembly manual shows a circular style clip to attach the lower part of the shift Z-bar to the adjusting rod/pin. The upper is a slide clip according to the assembly manual and supported by what I've seen on original cars. Seems strange that the lower one would be different.
Any input? The car is a late April '68 Metuchen GT350 4sp convertible.
Bob Gaines:
--- Quote from: caspian65 on December 12, 2017, 12:00:36 AM ---The assembly manual shows a circular style clip to attach the lower part of the shift Z-bar to the adjusting rod/pin. The upper is a slide clip according to the assembly manual and supported by what I've seen on original cars. Seems strange that the lower one would be different.
Any input? The car is a late April '68 Metuchen GT350 4sp convertible.
--- End quote ---
Do you mean a wave washer?
CharlesTurner:
--- Quote from: Bob Gaines on December 12, 2017, 12:10:51 AM ---Do you mean a wave washer?
--- End quote ---
No, it's a circular clip, like I've seen on Hurst shift rods.
TLea:
Charles I’ve never seen anything but the hairpin clip on the lower Rod
CharlesTurner:
--- Quote from: TLea on December 12, 2017, 09:27:15 PM --- Charles I’ve never seen anything but the hairpin clip on the lower Rod
--- End quote ---
Me either, just wanted to make sure based on what is in the assembly manual.
Navigation
[0] Message Index
[#] Next page
Go to full version