Author Topic: 1970 Mach 1 - Radiator finish question  (Read 2007 times)

Offline 67shelby

  • Newbie
  • *
  • Posts: 33
  • Just jackin' around
1970 Mach 1 - Radiator finish question
« on: October 09, 2010, 12:33:31 PM »
What is the finish on a 1970 AT radiator, the connector for the transmission cooling lines and the petcock?
Lorne Willard - MCA 38287

1965 GT Coupe, 1966 Convertible, 1967 Shelby GT350, 1968 Coupe, 1970 SCJ Mach 1,2003 Mach 1, 2007 Shelby, 2013 GT Vert
MCA Certified: 65-66 Concours, 67-68 Concours, 69-70 Concours, 71-73 Concours, 65-66 Concours Shelby, 67-68 Concours Shelby, 69-70 Concours Shelby, OD, DD

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24229
Re: 1970 Mach 1 - Radiator finish question
« Reply #1 on: October 09, 2010, 08:41:50 PM »
What is the finish on a 1970 AT radiator, the connector for the transmission cooling lines and the petcock?

Originally the radiator was painted a pretty glossy lacquer black that quickly dulled after a few good drives

Must say that the next two are not so easy since these are not often photographed and originals, normally, are in poor condition to provide us with any clues

Don't believe that the brazed automatic trans fittings were masked off at time of painting and by the looks of at least the period service replacements (same suppliers so practices should have been the same of very similar at the time) it appears that the petcock was in place and painted.

Hope this helps
Jeff Speegle

Anything worth doing is worth doing concours ;)