Author Topic: Tac wiring  (Read 2636 times)

Offline BMRBill

  • Newbie
  • *
  • Posts: 21
Tac wiring
« on: October 29, 2009, 06:51:05 PM »
I'm in process of installing the original tac in the 66 shelby I am restoring. It was not hooked up when I disassembled the car so I am trying to find out the proper routing of the wire that is run to the neg side of the coil. Hope somebody has some info on this.

Offline Bob Gaines

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 8953
Re: Tac wiring
« Reply #1 on: October 29, 2009, 10:32:37 PM »
The wire red wire to the coil was on the 65 Shelby tach . The 66 Shelby tach is routed to the factory location in the wiring harness. The repro 66 Shelby tach uses the coil location also.
Bob Gaines,Shelby enthusiast, Shelby collector , Shelby concours judge SAAC,MCA,Mid America Shelby

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24175
Re: Tac wiring
« Reply #2 on: October 29, 2009, 11:11:23 PM »
This might help someone


« Last Edit: October 29, 2009, 11:22:18 PM by J_Speegle »
Jeff Speegle

Anything worth doing is worth doing concours ;)

Offline BMRBill

  • Newbie
  • *
  • Posts: 21
Re: Tac wiring
« Reply #3 on: October 30, 2009, 10:35:09 PM »
Jeff could you fax me that wiring drawing I can't really make all of it out ?

Fax 1217 498 7154

Thanks

Bill

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 24175
Re: Tac wiring
« Reply #4 on: October 30, 2009, 10:39:12 PM »
Jeff could you fax me that wiring drawing I can't really make all of it out ?

No fax on this end. Maybe email me (PM for the address) and I can send it as an attachment.  Have you tried to save the picture I posted to your hard drive then open it with a viewer to increase the size?

Just a thought
Jeff Speegle

Anything worth doing is worth doing concours ;)