Author Topic: Anyone use Ospho as a Phosphating solution?  (Read 1751 times)

Offline 390Pony

  • Newbie
  • *
  • Posts: 44
  • It's all Good
Anyone use Ospho as a Phosphating solution?
« on: May 28, 2012, 03:26:09 PM »
I'm looking to try and give phosphating a try based on the excellent write up. I have a few quarts of Ospho that I've used to keep rust off bare metal until I'm ready to paint. Has anyone used it with succes to make a phosphating solution in which to cook the parts ? If so, what dilution rate with water did you find worked well ?

Offline jwc66k

  • Hero Member
  • *****
  • Posts: 7098
Re: Anyone use Ospho as a Phosphating solution?
« Reply #1 on: May 28, 2012, 04:39:08 PM »
Not knowing what chemicals and what percentages are in Ospho, I would try a 5/16-18 bolt that has been beadblasted in one ounce of solution to a gallon of 180-200F water for 3 minutes, a second bolt for 5 minutes and a third for 10 minutes. Air dry then spray with WD-40. Then add another ounce of solution and repeat with three more bolts. You will get different shades of "grey" which you can use to approximate the metal finish you want. Don't forget to use a stainless steel pan and tools.
Jim
I promise to be politically correct in all my posts to keep the BBBB from vociferating.