ConcoursMustang Forums

Restoring - General discussions that span across many different groups of years and models => Processes, Products & Techniques => Topic started by: BKnapp on February 18, 2017, 08:10:30 PM

Title: Another Evaporust question
Post by: BKnapp on February 18, 2017, 08:10:30 PM
I am in the process of cleaning up some parts and am wondering if I can soak the entire idler arm assembly in evaporust? Will I run into problems with it degrading the grease in the bearing or anything? The same question for the fan clutch. I worry about soaking moving parts in evaporust.

Thanks!
Title: Re: Another Evaporust question
Post by: Bob Gaines on February 18, 2017, 11:44:10 PM
I am in the process of cleaning up some parts and am wondering if I can soak the entire idler arm assembly in evaporust? Will I run into problems with it degrading the grease in the bearing or anything? The same question for the fan clutch. I worry about soaking moving parts in evaporust.

Thanks!
The possibility exists that the plating or shiny surface will be degraded on the metal sleeve of the bushing after being exposed to the evaporust. There is no bearing or grease in a idler arm to harm.  I will be surprised if the idler arm does not have cracked rubber bushing if it has never been rebuilt. If the rubber is dry rotting at the least it will not look new at the worst it needs rebuilt. The rubber needs to be soft enough to twist and snap back.  The rubber bushings that press into the cast steel arm have a shiny steel outer casing. 
Title: Re: Another Evaporust question
Post by: jwc66k on February 19, 2017, 12:59:18 PM
I am in the process of cleaning up some parts and am wondering if I can soak the entire idler arm assembly in evaporust?
I would remove the bushing first, with the intent on replacing it, then do the Evaporust steps.
Read the warning on the jug - you got a week or two before rust sets in.
The same question for the fan clutch. I worry about soaking moving parts in evaporust.
Any liquid, Evaporust included, will get into a moving assembly. The instructions include a rinse in water after an Evaporust treatment. As far as I'm concerned, that is a recipe for more rust. What I've considered, but haven't tried, is to use brake cleaner to blast out any remaining water on a moving assembly. I would not use a spray oil (Wd-40) unless you are at the final step, aka done (no paint, no plating, etc).
Jim