ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1968 Mustang => Topic started by: CharlesTurner on December 29, 2017, 06:33:36 PM

Title: Convertible well liner plastic reinforcement for edges
Post by: CharlesTurner on December 29, 2017, 06:33:36 PM

Does anyone know where to purchase the correct size plastic strip used to reinforce the edges of original well liners?  It's black shiny plastic, semi-rigid, 1" wide and about 1/24" (0.041") thick.  Ideally, could buy in a roll.

On a 67-68, it was used along the top where the well liner screws to the convertible tack bars and where the well liner screwed down to the trunk floor.  It was also used on 65-66, but I don't have an original well liner here to know if it was the same dimensions.

Title: Re: Convertible well liner plastic reinforcement for edges
Post by: CharlesTurner on December 31, 2017, 03:18:30 PM

Moved to 67/8 section... anyone?