Author Topic: 1969 rocker molding install  (Read 9028 times)

Offline Chris Thauberger

  • Jr. Member
  • **
  • Posts: 69
  • Quality is doing it right when no one is watching
Re: 1969 rocker molding install
« Reply #15 on: December 25, 2017, 02:46:12 PM »
I realize this post is older than I am, but though I would post for the next guy.

You may or may not find this helpful.  :)

Chris






« Last Edit: December 25, 2017, 03:03:57 PM by Chris Thauberger »

Offline Chris Thauberger

  • Jr. Member
  • **
  • Posts: 69
  • Quality is doing it right when no one is watching
Re: 1969 rocker molding install
« Reply #16 on: December 25, 2017, 03:01:50 PM »
My San Jose car had studs welded to the body, same as the pillar medians.:

Installed with:

This stud welder is used to install copper studs that go into a slide hammer for pulling dents.




NOT the "T" top studs seen around the window openings and later rockers.


Chris


Offline Brian Conway

  • Hero Member
  • *****
  • Posts: 1623
Re: 1969 rocker molding install
« Reply #17 on: December 25, 2017, 07:35:55 PM »
Thanks for the post.  Always great to have the original FORD instructions.  Brian
5RO9A GT  4 Spd Built 5/29/65
9TO2R SCJ 4 Spd Built 9/19/68
Owner Driver Mechanic
San Diego, Ca.