Author Topic: Convertible windshield moldings, clip locations?  (Read 1300 times)

Offline CharlesTurner

  • Charles Turner
  • Administrator
  • Hero Member
  • *****
  • Posts: 7614
Re: Convertible windshield moldings, clip locations?
« Reply #15 on: December 21, 2017, 09:49:46 PM »
Well, there was at least 1 clip in the right location on each side.  Then there are 2 screws that hold the molding to the pillar on the back side.  The weather-strip channel goes over that edge with more screws.  The lower edge is clipped into the edge of the lower molding at the upper half is held down by the top molding.

Technically, there is enough other contact points to keep the pieces in place, but it's not an ideal fit.  I'm guessing the assembly plant just installed the moldings and didn't give a hoot about any issues, so long as it got by QA.
Charles Turner - MCA/SAAC Judge
Concours Mustang Forum Admin