ConcoursMustang Forums
1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1966 Shelby => Topic started by: 6S1284 on June 23, 2017, 02:53:58 PM
-
I bought shelby lighter springs for my fiberglass/steel frame hood and it will not stay open.
Any suggestions from this esteemed group on what to do next?
BTW, almost done!
Thanks
Dave
-
I bought shelby lighter springs for my fiberglass/steel frame hood and it will not stay open.
Any suggestions from this esteemed group on what to do next?
BTW, almost done!
Thanks
Dave
Many factory 66 GT350's had one regular Mustang spring and the other side the lighter spring. Side didn't seem to matter. Try that.
-
Many factory 66 GT350's had one regular Mustang spring and the other side the lighter spring. Side didn't seem to matter. Try that.
Hi Bob -
It works but the hood sits a bit higher on the side with the "regular" spring. Will this eventually damage the hood?
Thanks
Dave
-
Hi Bob -
It works but the hood sits a bit higher on the side with the "regular" spring. Will this eventually damage the hood?
Thanks
Dave
It should not on a steel innerstructure hood. The steel gives it extra strength in that area. Remember this was common on many factory 66 GT350's with no significant reports of problems over the years.
-
It should not on a steel innerstructure hood. The steel gives it extra strength in that area. Remember this was common on many factory 66 GT350's with no significant reports of problems over the years.
+1