Author Topic: 1967 Mustang w/Big Block what finish are the block plates for the engine mounts  (Read 698 times)

Offline motor head 428

  • Newbie
  • *
  • Posts: 35
What finish are the block plates that bolt to the engine, that the motor mounts attach to.And the finish for the attaching bolts. For a Big Block Engine in a 1967 Mustang. Thank You
« Last Edit: June 23, 2017, 08:59:27 PM by motor head 428 »

Offline Bob Gaines

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 8954
What finish are the block plates that bolt to the engine, that the motor mounts attach to.And the finish for the attaching bolts. For a Big Block Engine in a 1967 Mustang. Thank You
Bare steel on the brackets that bolt to the block. I would use P/O on the bolt ,light P/O on the washer and zinc silver on the nut. You need to protect the bare steel brackets against rust. I use T9 Boe Shield.
Bob Gaines,Shelby enthusiast, Shelby collector , Shelby concours judge SAAC,MCA,Mid America Shelby

Offline motor head 428

  • Newbie
  • *
  • Posts: 35
Thank You, Bob