Author Topic: 1966 Tail Light Housings  (Read 1718 times)

Offline Twilight65

  • Gold Level Subscriber
  • Sr. Member
  • *****
  • Posts: 380
1966 Tail Light Housings
« on: October 30, 2009, 07:48:16 PM »
Can someone tell me the correct hardware to use when installing the tail light housing to the tail light panel. When I was dismantling, I had one side that just had the stamped nuts on all four studs, while the other side had stamped nuts on the two bottom studs and stamped nuts with an angle metal piece on the two top studs. My 65 is the latter with angle pieces on the top two. Had me wondering which is the correct way. ???
Thanks,
Dave
65 Coupe Dearborn Scheduled Build July 9,1965 289/C4
66 Sprint Conv. Dearborn Scheduled Build May 13, 1966 200/C4

Offline carlite65

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 2362
Re: 1966 Tail Light Housings
« Reply #1 on: October 30, 2009, 08:08:41 PM »
you should have the angled pieces on the top of both housings.
5F09C331248

Offline Twilight65

  • Gold Level Subscriber
  • Sr. Member
  • *****
  • Posts: 380
Re: 1966 Tail Light Housings
« Reply #2 on: October 30, 2009, 11:33:08 PM »
Thank you Sir. Now I'll need to find a couple of replacements.
Dave
65 Coupe Dearborn Scheduled Build July 9,1965 289/C4
66 Sprint Conv. Dearborn Scheduled Build May 13, 1966 200/C4

Offline carlite65

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 2362
Re: 1966 Tail Light Housings
« Reply #3 on: October 31, 2009, 11:01:40 AM »
va mustang sells those.
5F09C331248