Author Topic: Photo Request - under dash vacuum motor bracket - 1969 GT350  (Read 179 times)

Offline 6S1284

  • Newbie
  • *
  • Posts: 25
Photo Request - under dash vacuum motor bracket - 1969 GT350
« on: February 06, 2018, 12:11:49 AM »
After two years I am in reassembly mode of my 69 GT350 and I did not take good enough pictures/notes on how this stuff bolts up underneath the dash. 
I am lost on the tilt-away gear and how it all bolts back in.   I searched everywhere but could not find references/pictures.

Thanks for any help-


Offline Bob Gaines

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 4523
Re: Photo Request - under dash vacuum motor bracket - 1969 GT350
« Reply #1 on: February 06, 2018, 03:01:21 AM »
After two years I am in reassembly mode of my 69 GT350 and I did not take good enough pictures/notes on how this stuff bolts up underneath the dash. 
I am lost on the tilt-away gear and how it all bolts back in.   I searched everywhere but could not find references/pictures.

Thanks for any help-
Hope this helps.
Bob Gaines,Shelby enthusiast, Shelby collector , Shelby concours judge SAAC,MCA,Mid America Shelby

Offline J_Speegle

  • Administrator
  • Hero Member
  • *****
  • Posts: 15077
Re: Photo Request - under dash vacuum motor bracket - 1969 GT350
« Reply #2 on: February 07, 2018, 12:38:04 AM »
Real hard to see things once their all installed so I think Bob's posting of the illustrations and these pictures it provides a more complete look at the installation

Hope this helps



Jeff Speegle

Anything worth doing is worth doing concours ;)

Offline 6S1284

  • Newbie
  • *
  • Posts: 25
Re: Photo Request - under dash vacuum motor bracket - 1969 GT350
« Reply #3 on: February 10, 2018, 11:06:37 PM »
Once again saved by the Speegle Gaines dynamic duo!