« previous next »
Pages: [1]   Go Down

Author Topic: 65 conv A pillar holes  (Read 458 times)

Offline fmr187

  • Jr. Member
  • **
  • Posts: 95
65 conv A pillar holes
« on: April 29, 2020, 06:14:19 PM »
On my 65 there are 4 holes in the A pillar on the front side. I know that 3 of them are for the windshield molding clips. But I cant figure out what the 4th hole is for. I cant find anything in any of the assemble manual diagrams. Attached are 2 pics. The hole is question in the middle of the pic and it is located more toward the outside of the car than the 3 for the molding. Anyone know what this hole is for?
Logged
65 Convertible born in Dearborn on Feb 10

Offline CharlesTurner

  • Charles Turner
  • Administrator
  • Hero Member
  • *****
  • Posts: 7621
Re: 65 conv A pillar holes
« Reply #1 on: April 29, 2020, 06:19:09 PM »
Early cars had a screw there, which matched up to a notch on the molding, I'd guess for alignment.

The screw was the same as used on the glove box door tether cable.
Logged
Charles Turner - MCA/SAAC Judge
Concours Mustang Forum Admin
Pages: [1]   Go Up
« previous next »