ConcoursMustang Forums
1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1971 - 1973 => Topic started by: nham3407 on May 21, 2013, 05:44:00 PM
-
I have a Dearborn 01/72 Mach 1, 351-2V Mark (aka svo2scj) provided a picture of the single exhaust system he received from another party. The picture is not at an angle where I can see if there is a clamp at the intermediate pipe to muffler and muffler to tailpipe. I have an OE muffler I recently acquired cut off of a car in 72 and put away in the shed. It is in very good condition but it was cut with a saws all very close to the center chamber so it will need some new extensions welded on. I am trying to find out if the OE system was welded from the intermediate back?
-
Originally the intermediate pipe (forward of the muffler) and the over-axle pipe (aft of the muffler) would have been welded to the muffler. Ford offered the three pieces individually as service parts for a while, but then went to fully welded assemblies before they became obsolete.
Scott
-
Great. Thank you.