« previous next »
Pages: [1]   Go Down

Author Topic: Power Steering Control Valve Finish  (Read 502 times)

Offline 1965pony

  • Newbie
  • *
  • Posts: 16
Power Steering Control Valve Finish
« on: February 22, 2020, 07:23:14 PM »
What's the correct finish for the power steering control valve on a 65?  The car was built early Nov. 64 at San Jose.  Thanks!
Logged

Offline CharlesTurner

  • Charles Turner
  • Administrator
  • Hero Member
  • *****
  • Posts: 7624
Re: Power Steering Control Valve Finish
« Reply #1 on: February 23, 2020, 02:35:11 AM »
The cast control valve body was natural cast iron.  I usually do a 30s dunk in phosphate to darken it slightly.

The end plate would be natural stamped steel.

End cap was aluminum die-cast.
Logged
Charles Turner - MCA/SAAC Judge
Concours Mustang Forum Admin

Offline 1965pony

  • Newbie
  • *
  • Posts: 16
Re: Power Steering Control Valve Finish
« Reply #2 on: February 23, 2020, 12:24:17 PM »
Thanks!
Logged
Pages: [1]   Go Up
« previous next »