Author Topic: 1967 Mustang fastback Sunvisor rod and brackets  (Read 383 times)

Offline Z67Fback

  • Jr. Member
  • **
  • Posts: 69
1967 Mustang fastback Sunvisor rod and brackets
« on: September 27, 2020, 09:21:13 AM »
Both of my original sunvisor brackets and rods are severely pitted. I am contemplating to see if these can be re-chromed or are there any quality replacements? Any pitfalls removing these or reinstalling?

Thank you

Scott
1967 Fastback, C Code, 4 Sp MT, 7T02C226959 Build Date 4/11/67. Built in Metuchen, NJ

Offline ruppstang

  • Hero Member
  • *****
  • Posts: 3839
Re: 1967 Mustang fastback Sunvisor rod and brackets
« Reply #1 on: September 27, 2020, 10:04:19 AM »
The base of the brackets are pot metal and it is very difficult and expensive to repair. I would look for a better used set or by a set of reproductions.

They are easy to remove and replace.

Offline jwc66k

  • Hero Member
  • *****
  • Posts: 7136
Re: 1967 Mustang fastback Sunvisor rod and brackets
« Reply #2 on: September 27, 2020, 12:53:53 PM »
The base of the brackets are pot metal and it is very difficult and expensive to repair. I would look for a better used set or by a set of reproductions.
They are easy to remove and replace.
True.
To chrome properly, everything needs to be disassembled. That's easy. Putting everything back together- that's hard.
Jim
I promise to be politically correct in all my posts to keep the BBBB from vociferating.