1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year > 1967 Mustang

Heater box rebuild

<< < (2/2)

dave6768:
Be super careful when removing the clips that hold the two halves together.  Don't break any of the tabs.

jwc66k:

--- Quote from: dave6768 on March 31, 2024, 12:17:13 PM ---Be super careful when removing the clips that hold the two halves together.  Don't break any of the tabs.

--- End quote ---
Use two screwdrivers, one on each side stuck in the "dip's' upturn" and gently pry the dip apart using both hands. It's an unwieldy operation, but it should keep the case intact at the clips location. 
Jim

Navigation

[0] Message Index

[*] Previous page