I have this set of 1966 tie rod ends for my c-code conv't w/ pwr steering.
They are like new so I hate to toss them. A new set of concours jobs is $500+.
Does anyone know if the rubber boots with the steel rings will fit on them?
The O.D. in that area is 1.425.
NPD has a concours set, and a near concours set that both caution they may not fit.
I know the grease zerks are wrong. I'm gonna fill them w/ grease, remove the zerks,
weld up the holes with .026 wire at very cool temp, and then put a steel plug on with
structural adhesive that looks like the 2nd picture.
Bryan