ConcoursMustang Forums

Restoring - General discussions that span across many different groups of years and models => Processes, Products & Techniques => Topic started by: mtinkham on February 20, 2020, 01:45:10 PM

Title: Straightening a fin on the exterior cast air extractor - 67 Fastback B-pillar
Post by: mtinkham on February 20, 2020, 01:45:10 PM

I was wondering if anyone has attempted to straighten the fins on a cast air extractor located on the B-pillar of a 67/68 fastback. I have an original extractor with a fin that has been pushed in approximately 3/16". I can post a picture if further clarification is needed.

I know cast materials are not very flexible. But wondered if anyone had a process they'd be willing to share.

Thanks,
Mark