Author Topic: Windshield squirters  (Read 1256 times)

Offline ruppstang

  • Hero Member
  • *****
  • Posts: 3850
Windshield squirters
« on: March 05, 2020, 10:07:34 PM »
I was told that the 68 Shelby's had a letter K on the windshield squirters. I have 15-20 of them and have not found a K on any of them. Maybe this is a Metuchen plant supplier thing.
« Last Edit: March 06, 2020, 09:00:27 AM by carlite65 »

Offline ruppstang

  • Hero Member
  • *****
  • Posts: 3850
Re: Windshield squirters
« Reply #1 on: March 07, 2020, 12:32:58 AM »
I found the K on this unrestored 68 GT 350. It is hard to make out in the picture but is to the left of the screw.

Thanks for the fix Fred.

Offline TLea

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 1120
Re: Windshield squirters
« Reply #2 on: April 19, 2020, 08:03:12 PM »
NJ thing. NJ nozzles and F tee also used different screw than D and SJ
Tim Lea  Shelby concours judge MCA, SAAC, Mid America

Offline ruppstang

  • Hero Member
  • *****
  • Posts: 3850
Re: Windshield squirters
« Reply #3 on: April 20, 2020, 12:02:46 AM »
NJ thing. NJ nozzles and F tee also used different screw than D and SJ

Yes that is what I thought. Those screws are tough to find out here.

Offline Coralsnake

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 882
Re: Windshield squirters
« Reply #4 on: April 21, 2020, 07:51:49 PM »
I think the original screws have a square end, AMK has some pointy screws that are very similar

Offline Bob Gaines

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 9036
Re: Windshield squirters
« Reply #5 on: April 21, 2020, 08:07:12 PM »
Yes that is what I thought. Those screws are tough to find out here.
Try 69/70 lower dash trim screws . The ones on ether end and the two on ether side of the center radio/heater controls ;)
Bob Gaines,Shelby enthusiast, Shelby collector , Shelby concours judge SAAC,MCA,Mid America Shelby