ConcoursMustang Forums
Restoring - General discussions that span across many different groups of years and models => Interior & Trunk => Topic started by: sparky65 on October 29, 2010, 05:46:25 PM
-
Is there a way to remove and reinstall the heater resistor switch from the heater case? the original switch in my busted up case looks nicer and I would like to swap it but I don't see how I can save the plastic clips that hold it in place.
-
You can drill out and replace the plastic rivets. Here's a link to a previous thread.
http://www.concoursmustang.com/forum/index.php?topic=798.msg4089#msg4089
-
The plastic pins can be pushed out from the back side and re-used.
-
Thanks Charles. I had tried that but couldn't get them to move. I just soaked them with WD-40 and then I was able to get them out.
-
Small tip screwdriver and a rubber mallet usually works.