Author Topic: 1970 Rear Axle Housing (Read 516 times)

fla2005 · « **on:** September 13, 2018, 01:18:07 PM »

Looking for a restorable 1970 Mustang rear axle housing for 9 inch ring gear and pinion set. Must be 1970 only.

Bob Gaines · « **Reply #1 on:** September 13, 2018, 05:22:29 PM »

Looking for a restorable 1970 Mustang rear axle housing for 9 inch ring gear and pinion set. Must be 1970 only.

Help me understand the 1970 only features that you are concerned about. I have several nice ones.Bob

fla2005 · « **Reply #2 on:** September 14, 2018, 10:18:00 AM »

Apparently the 1970 housings have two threaded holes on the upper left side. One hole for vent and one hole for attaching brakeline related parts.

J_Speegle · « **Reply #3 on:** September 14, 2018, 05:54:05 PM »

Apparently the 1970 housings have two threaded holes on the upper left side. One hole for vent and one hole for attaching brakeline related parts.

Bob Gaines · « **Reply #4 on:** September 14, 2018, 10:59:13 PM »

Apparently the 1970 housings have two threaded holes on the upper left side. One hole for vent and one hole for attaching brakeline related parts.

69 BB also had the two holes . One was for the brake line and the other for the vent. If you can't find one contact me .I may be able to help.

fla2005 · « **Reply #5 on:** September 15, 2018, 11:50:21 AM »

Bob:

Will appreciate any help you can provide in locating the axle housing. Thanks.

News: