« previous next »
Pages: [1]   Go Down

Author Topic: Kelsey Hayes or Bendix - 69 GT350  (Read 1549 times)

Offline ddonzella

  • Full Member
  • ***
  • Posts: 167
Kelsey Hayes or Bendix - 69 GT350
« on: August 11, 2015, 05:23:02 PM »
June 12, 69 gt350. Is the rear brake backing plate supposed to be Bendix or kelsey hayes?
« Last Edit: August 16, 2015, 11:23:51 PM by J_Speegle »
Logged

Offline ddonzella

  • Full Member
  • ***
  • Posts: 167
Re: Kelsey Hayes or Bendix
« Reply #1 on: August 11, 2015, 05:23:58 PM »
Sorry! Dearborn!
Logged

Offline Bob Gaines

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 9001
Re: Kelsey Hayes or Bendix
« Reply #2 on: August 11, 2015, 06:31:08 PM »
Quote from: ddonzella on August 11, 2015, 05:23:02 PM
June 12, 69 gt350. Is the rear brake backing plate supposed to be Bendix or kelsey hayes?
Typically they were Bendix. less typical KH . I have actually seen one side Bendix and one side KH more times then I have seen both sides KH.FYI be sure to use the correct KH backing plate plug (cross hatch texture ) or the Bendix (starts with 8A) plug depending on plate.
Logged
Bob Gaines,Shelby enthusiast, Shelby collector , Shelby concours judge SAAC,MCA,Mid America Shelby

Offline ddonzella

  • Full Member
  • ***
  • Posts: 167
Re: Kelsey Hayes or Bendix
« Reply #3 on: August 11, 2015, 10:02:18 PM »
ok! Thank You
Logged

Offline Aussiemach

  • Silver Level Subscriber
  • Full Member
  • ****
  • Posts: 173
Re: Kelsey Hayes or Bendix
« Reply #4 on: August 11, 2015, 11:20:56 PM »
Quote from: Bob Gaines on August 11, 2015, 06:31:08 PM
I have seen both sides KH.FYI be sure to use the correct KH backing plate plug (cross hatch texture ) or the Bendix (starts with 8A) plug depending on plate.

Thanks Bob for the info, my 69 Mach1 is as you describe
Logged
1969 Mach 1 351w FMX Built in San Jose, February 26 1969

Offline TLea

  • Global Moderator
  • Hero Member
  • ****
  • Posts: 1119
Re: Kelsey Hayes or Bendix
« Reply #5 on: August 15, 2015, 10:39:27 AM »
Quote from: Bob Gaines on August 11, 2015, 06:31:08 PM
Typically they were Bendix. less typical KH . I have actually seen one side Bendix and one side KH more times then I have seen both sides KH.FYI be sure to use the correct KH backing plate plug (cross hatch texture ) or the Bendix (starts with 8A) plug depending on plate.
+1. In addition to different adjuster lug there is also a difference in wheel cylinder attaching bolt
Logged
Tim Lea  Shelby concours judge MCA, SAAC, Mid America
Pages: [1]   Go Up
« previous next »