ConcoursMustang Forums
1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1967 Mustang => Topic started by: jackrob on November 14, 2017, 10:15:37 AM
-
How does the lower screws on the heater control panel (no AC) mount on the dash. I have some slots down there but no holes.
Thanks
Jack
-
I think you need 2 8-32x1/2” hex head bolts and nuts. Check out Jims hardware spreadsheet in the Library, along with the Osborn Assembly manual.
-
Thanks for the reply. Are you saying to screw the bolts through the slots?
-
yes
-
IIRC the nut goes on the inside of the dash and the bolt goes up through the slots and threads into the nut. It is a challenge getting them to mate up if you have a fully installed interior. I think they went to a spring nut in 68.
-
Thanks Guys!!!