ConcoursMustang Forums
1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1969 Mustang => Topic started by: 13Outlaw on August 03, 2016, 09:50:58 PM
-
Hello all, been away for awhile and trying to get going back on the car. I got the new inner/outer fender wells in, full quarters in, etc. Does anyone have the measurements of exactly where to cut the staggered shock hole? Also, I was needing the measurements for all the brackets that go on the wheel wells, and rear seat area. I had all the measurements written down and simply can not find them. 1969 R-Code 4 Speed. Thanks for any help.
Shane
-
I should mention I changed the rear transition pan and therefore there is no hole cut for the Staggered Shock. Thanks
-
http://sancospecialties.com/stagger.htm
I would contact Forrest, I'm sure he could help you out
-
Don't have either of the 69's I have with staggered rear shocks close by so can't take the measurements (no 69's at home currently) . Too mad they were not measured or a template made before those panels were replaced on your car.
-
Thanks all! Jeff I did take measurements, but I can not find the binder I had them in. I did snap a picture wit my phone, but that isn't a lot of help obviously, just for the general area. Thanks again.
-
Thanks all! Jeff I did take measurements, but I can not find the binder I had them in. I did snap a picture wit my phone, but that isn't a lot of help obviously, just for the general area. Thanks again.
Ouch - feel for you. Planned ahead and it didn't work out. Happens to all of us
-
Yea thanks again, I'll let you all know how it turns out.