ConcoursMustang Forums

1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1970 Mustang => Topic started by: Blown351stang on February 03, 2018, 06:05:49 AM

Title: 70 Mach1 Light Wiring Tag
Post by: Blown351stang on February 03, 2018, 06:05:49 AM

How was the light wiring harness tag put on? wrapped around one wire or the whole harness my one may of been just on one wire.
(https://s6.postimg.cc/qwp5zx7g1/P1020882.jpg) (https://postimg.cc/image/5zsxv99f1/)

Title: Re: 70 Mach1 Light Wiring Tag
Post by: J_Speegle on February 03, 2018, 02:50:24 PM

Around the whole loom over the outer wrapping so that there is not tail.  Maybe back from the end 6 inches or so

May have a picture

Title: Re: 70 Mach1 Light Wiring Tag
Post by: Blown351stang on February 03, 2018, 06:56:13 PM

Quote from: J_Speegle on February 03, 2018, 02:50:24 PM

Around the whole loom over the outer wrapping so that there is not tail.  Maybe back from the end 6 inches or so

May have a picture

If you have a picture Jeff that would be good.
There was some tag on the blue/red wire but it was painted over with black paint and turned to dust when it was touched.

Title: Re: 70 Mach1 Light Wiring Tag
Post by: J_Speegle on February 03, 2018, 07:19:32 PM

Sorry I was off by a inches off or so from memory  ::) It would be foward of where your picture shows. In front of the mounting clips

The picture shows the location on this 70 Dearborn example. Part of it is blocked from view because the wire loom cover that is coming off. Surprised it only took a couple of minutes to find the picture (remember where I might find the example)  sometimes this can take a half hour or so going through pictures

(http://www.concoursmustang.com/forum/gallery/9/6-030218181816.jpeg)