ConcoursMustang Forums
1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1967 Mustang => Topic started by: 1965GTFB on April 20, 2013, 05:33:02 PM
-
Got the 67 quarter panel ornament pads (as it NPD calls it), seals (as I call it) form NPD. They seem to be too big and sloppy and too thick. Pushing on the ornament very hard from the outside I still can't compress it enough for the ornament to be flush with the body and parts of it stick out due to being too big. I don't want to risk trying to compress it by cranking down on the mounting nuts and stripping them.
I'm guessing that I'm going to need to spend a bunch of time trimming and cutting and gluing to make this $3.25 part fit right, the way that it should have been made.
Are there any good alternatives? Sealers, make my own, or?