1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year > 1964 1/2 - 1965
? Cowl to Hood seal Brackets
YELLOWBOSS2:
On a May 65 SJ car should the metal brakets at the end of the cowl to hood seal be bent down over the screws? If they are, does anyone know of a good way to bend them down?
Thanks,
Dave
carlite65:
no. but the rubber is cut even with the bracket.
Twilight65:
I didn't cut my rubber off even like carlite65 said, but here's a picture of my 65 Dearborn with original brackets and new rubber. I think its pretty much the same for a San Jose. Metal bracket kind of supports the rubber at ends no bending.
Dave
J_Speegle:
Hope this helps - all 66 San Jose
Looks to be about 1/16" - 1/8"
YELLOWBOSS2:
Thanks for the responses. I was very close to bending the brackets down.
Dave
Navigation
[0] Message Index
[#] Next page
Go to full version