ConcoursMustang Forums
1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1967 Mustang => Topic started by: 67gtasanjose on April 22, 2017, 09:33:03 AM
-
Looking for an ideas on what to use on a 67 Mustang w/Tilt-away column to sleeve over the Turn signal harness wiring coming out the lower port of the steering column. It seems there was something there before but now I have nothing.
-
The tilt column had its own unique wire cover. It is much like the non tilt column cover but a bit shorter. I see if I can get some photos.
-
I should have something also. From a color and texture perspective I think heat shrink tubing (without shrinkage) would be a decent substitute
-
I should have something also. From a color and texture perspective I think heat shrink tubing (without shrinkage) would be a decent substitute
+1
That is where I would start. Might compare a few different suppliers since the thickness may vary between them but other than a slight thickness difference and a less smooth or slightly glossy finish I thing it would work for you and would be the first place I would start
-
I've used this harness sleeving for other purposes. I think the semigloss tubing would be a good match if it is big enough. Kurt
http://www.cycleterminal.com/sleeve-tubing.html
-
I've used this harness sleeving for other purposes. I think the semigloss tubing would be a good match if it is big enough. Kurt
http://www.cycleterminal.com/sleeve-tubing.html
Thanks Kurt, looks good
OK, need input from somebody with an original...Sizes available that might match, 9/16", 5/8" or 3/4" (I.D.), available by the foot, up to 20-foot lengths :o