ConcoursMustang Forums
1st Generation 1964 1/2 - 1973 - Questions & general discussions that apply to a specific year => 1964 1/2 - 1965 => Topic started by: MustangAndFairlane1867 on November 16, 2017, 12:10:43 PM
-
Jim
If so, he used a lot of them. I’ve see those on numerous ‘65s. BTW, was the trunk lid tension rod arrangement—including brackets and fasteners, etc.—the same on coupes and convertibles of the same year?
Ron
-
Not that I recall. I think the coupe had two rods?
-
Split this discussion off from one focusing on 65-6 fastback trunk lid torsion rods
So here are some examples so you can draw your own conclusions
On coupes the two rods are held to the body midway between the drivers side and passenger side trunk hinges. On convertibles there thewre is no midway unpainted retainer/bracket
Coupe
(http://www.concoursmustang.com/forum/gallery/9/6-191117163704.jpeg)
Convertible
(http://www.concoursmustang.com/forum/gallery/9/6-191117163913.jpeg)
Comparison of hinges and rod locations
Drivers side coupe
(http://www.concoursmustang.com/forum/gallery/9/6-191117163738.jpeg)
(http://www.concoursmustang.com/forum/gallery/9/6-191117163721.jpeg)
(http://www.concoursmustang.com/forum/gallery/9/6-191117163639.jpeg)
Drivers side convertible
(http://www.concoursmustang.com/forum/gallery/9/6-191117163904.jpeg)
(http://www.concoursmustang.com/forum/gallery/9/6-191117163854.jpeg)
(http://www.concoursmustang.com/forum/gallery/9/6-191117163841.jpeg)
Passenger side coupe
(http://www.concoursmustang.com/forum/gallery/9/6-191117163804.jpeg)
(http://www.concoursmustang.com/forum/gallery/9/6-191117163752.jpeg)
Passenger side convertible
(http://www.concoursmustang.com/forum/gallery/9/6-191117163913.jpeg)
-
Not sure if there is a question about the difference between coupe and convertible torsion rods? If so, they are definitely different, have run into the issue before.
-
Not sure if there is a question about the difference between coupe and convertible torsion rods? If so, they are definitely different, have run into the issue before.
Lookign at both but there appear to be shaped differently at the end that connects to the top of the hinge
-
Not sure if there is a question about the difference between coupe and convertible torsion rods? If so, they are definitely different, have run into the issue before.
Different part numbers in the 66 Mustang Body Assembly Manual would indicate a different design.
(Books are your friends too.)
Jim