ConcoursMustang Forums

Marketplace => Wanted Ads => Topic started by: C5ZZKGT on June 13, 2011, 09:00:27 PM

Title: '65 ALTERNATOR CONDERSOR WANTED
Post by: C5ZZKGT on June 13, 2011, 09:00:27 PM

C5TA-18827-A is what I understand the part number is, either a GOOD used, NOS or CORRECT Reproduction-(if they exist)  THANKS!!!!

Title: Re: '65 ALTERNATOR CONDERSOR WANTED
Post by: Twilight65 on June 14, 2011, 09:47:54 AM

Rick, I've heard you can get these sometime from deadnutson. You may try calling them.
Dave

http://www.deadnutson.com/page/page/2958685.htm

Title: Re: '65 ALTERNATOR CONDERSOR WANTED
Post by: C5ZZKGT on June 14, 2011, 10:15:06 AM

Dave, Thanks!!  I sent Jack an Email, Rick

Title: Re: '65 ALTERNATOR CONDERSOR WANTED
Post by: C5ZZKGT on July 09, 2011, 07:03:36 AM

Bump......still looking......

Title: Re: '65 ALTERNATOR CONDERSOR WANTED
Post by: C5ZZKGT on July 09, 2011, 04:45:03 PM

I actually found one in my parts stash-kinda ugly-how can I refinish it? I've cleaned it up with some steel wool but it needs more before I put it on my car.

Title: Re: '65 ALTERNATOR CONDERSOR WANTED
Post by: Bob Gaines on July 09, 2011, 05:17:15 PM

Quote from: C5ZZKGT on July 09, 2011, 04:45:03 PM

I actually found one in my parts stash-kinda ugly-how can I refinish it? I've cleaned it up with some steel wool but it needs more before I put it on my car.

If you had one of Eastwoods inexpensive zinc plating kits you could hook it and dip it in and about 3 minutes later it is plated. You can adjust the sheen with a light rub from a towel to a more abrasive extra fine steel wool. Usually I buff it with a course towel and it is good to go. You can of course send in to your local  plater with a minimum order and hope they don't break the wire off. I hope this helps . Bob

Title: Re: '65 ALTERNATOR CONDERSOR WANTED
Post by: C5ZZKGT on July 10, 2011, 01:22:07 PM

Thanks Bob!! This does help, I'll check out the Eastwood kit.

Title: Re: '65 ALTERNATOR CONDERSOR WANTED
Post by: C5ZZKGT on August 08, 2011, 02:30:42 PM

Still looking for a NICE one.
I've got the old one I had refinished the best I could and installed it-looks ok, but the connector has been replaced with a generic one and the wire is actually too short to plug in right.........Please check around for me, I'd sure appreciate it. Thanks!!

Title: Re: '65 ALTERNATOR CONDERSOR WANTED
Post by: Andrew@MagMustangs on August 26, 2011, 01:56:52 PM

If you are still looking for one, I just listed one in My Ebay Store. It is a Good Original. Andrew

http://stores.ebay.com/MagMustangs

Title: Re: '65 ALTERNATOR CONDERSOR WANTED
Post by: rodster on August 27, 2011, 11:08:56 PM

I'll look around and if I find one you can have it for the price of shipping....